Jack Hammer Adapter Compression Points It is actually 3" in

It is actually 3" in diameter and will make a hole large enough to accommodate a 2" Sch 40 pipe with a coupling

( Remove The point after marking the pipe)

Transfer the length of both lines

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

At a glance you will know if anything is missing

Jack Hammer Adapter Compression Points It is actually 3" inThis part is used to connect the Bullet Mole to a jack hammer so that the jack hammer can drive the Bullet Mole. It basically has 2 holes in it. One larger hole that will slide over the impact cap and one smaller hole that will recieve the sawed off blunted, 1 1 8" hex bit connected to the jackhammer. Eeither an electric or pneumatic jack hammer having a 1 1 8" hex shank may be used with the jack hammer adapter. NOTE: An Idea is to use an old. worn