Rivet shank diameters Ingestion-build-47182 conformance is achieved through implementation

conformance is achieved through implementation of conforming OSI Physical protocols that fulfil the Physical Service defined in this Recommendation | International Standard

this standard should only be used for guidance

Note 2: BS EN 12680-1 does not apply to austenitic steels and joint welds

in new shopping complexes and in alterations and extensions to existing shopping complexes

BS 8118-1:1991

Rivet shank diameters Ingestion-build-47182 conformance is achieved through implementation1 Scope This International Standard specifies two series of shank diameters of rivets for general use, except blind rivets, in the range from 1 mm up to and including 36 mm.