Plain bearings. Tolerances - Tolerances on form and position and surface roughness for shafts and thrust collars Ingestion-build-63114 This Part of this European

This Part of this European Standard sets out minimum requirements for the specific types of water to reduce the risk of corrosion

BS EN 12953 specifies requirements for inspection during and after construction

This document applies to air transfer devices of the following types:

and modification of cultural heritage about

They can be found in HD 605

Plain bearings. Tolerances - Tolerances on form and position and surface roughness for shafts and thrust collars Ingestion-build-63114 This Part of this EuropeanWhat is this standard about? This document specifies tolerances on form and position as well as the surface roughness of shafts, flanges and thrust collars as used in plain bearing units. It is applicable to journal or thrust plain bearing units or to a combination of both, installed either horizontally or vertically. This document is not applicable to crankshaft bearing units in combustion engines.